Separate names with a comma.
Mistery solved ,.. there was an Alu chip where the steel part should have been pressed in ,.. but it wasn't so it couldn't lock properly and the...
Hi i now played around with the Hermea (i had also some alignment problems with the aero and Vulcan) but the problem is the repeatability . I was...
So i changed my original E3D Toolchanger setup to have one hermea and 1 Aero + volcano nozzle to print The Bodens work fine but the hermea setup...
Hi Jaa, that is an great design i was about to draw and happily found yours do you share your files somewhere i would like to give it a try ,.....
hi that would be verry helpful and i added an hint at the build material where i would check the screws. Maybe a lot people don't check the ready...
if you mean that blue or red stuff as threadlock no the grub screws where dry before machine goes to final position i will use loctite 243 to...
Finally it was an mechanic error ,.. I don't know why i have overlooked it (maybe because i am fighting a cold an i am not 100% ,.. ) but on one...
Hi yes it is and M122 says it as well i measured it under load ( heating ) no change Now i have a verry strange situation i changed board ,...
Thank you spoon i did that dint need to go more than 100mm in x and y went back to the position and was in every try way ba more than an...
I thought it is about end switches https://forum.e3d-online.com/threads/first-print-and-now-strange-homing-issue-need-advice.3362/ but it isn't....
Now finally i can say it is not the end switches ...
Endswitches work now i remixed it for mine https://www.thingiverse.com/thing:3872395
FDM process yes but if you check https://www.solidscape.com/products/3d-printing-materials/wax/ as we want to buy the material because printer we...
Hi you are right i overlooked it my bad and for a 3d printer it is a strong motor ;)- (I do also small CNC Mills and Lathes ,.. )
My findings : The Head moves (by hand power off situation) have a lot of friction i am not sure that in the corners the small (no name ) motors...
I think they don't sell that for FDM any more it looks more like DLP now ...
Now fighting an E3D Toolchanger !
Now i have played around and switched on DEBUG and out an oc ti usb and see Steppers are loosing steps and i reduced first to 50% speed now to...
Wow thank you for the fast response ; I build the machine from 7-9th of Sept and used the actual https://github.com/e3donline/RepRapFirmware-SD...
Hi i did the build and have quite experience with Duet on an Hevo. So i tripple and double checked Toolchange drop works repeatable over days(i...
