Separate names with a comma.
Hi, A while since I ran my printer and Octoprint which is still installed. Did you follow the E3D install instructions to configure it? If so...
This was the post... https://forum.e3d-online.com/threads/my-first-print-using-octoprint-z-movement-counter-intuitive.999/
From a distant memory I don't remember many hiccups when following the instructions to a t. The one thing I vaguely remember and it will be in...
Original Octopi info from E3D found be using duckduckgo.com search terms "octopi E3D" https://wiki.e3d-online.com/BigBox_OctoPrint_Upgrade...
Look through this forum for "Duet" upgrade wired or wireless, contact Duet maker and see their forum too. Your possible major problem is did it...
Heh-Ho. The blue shroud that E3D provided for the original BigBox install could also be fitted in two different ways providing more or less...
A quick search in Duckduckgo.com gets lots of hits, I tried "e3d can't reach max temperature" results vary depending on what search terms you...
Use the power of the web and duckduckgo.com (search engin) search on... "E3D crimp tubes" and/or also read the install instructions... (just...
Any number of possibilities. A. First check is with E3D as to if these motors have a known problem (unlikely but always possible) otherwise it...
Can't help with the temp measurement other than get one of these cheapo ones that look like a gun and cast a laser beam. Maybe aim at other...
After many hours of searching (ok minutes) starting with "404010 fan" I found this search engine, rhymes with frugal or go duck duck and found...
Did you post on the Duet site? Far greater possibility of a response than from here. A link to any response there would be good though!
Can't say I have ever had this problem, just followed the E3D instructions on assembly and tightening at temperature and that's it. Could you say...
eeek, not a soldering iron :-) Superglue works but if the nut isn't quite straight then the act of inserting the screw will break it free, but I...
First, do you have the original resistance measurements from the heater (cartridges? not "blocks" ?) If you don't have these then you don't know...
Spray it with one of the clear (or even better coloured! ) lacquers used on car engine parts
I guess using the power supplied should work instead or be good enough. Is there that much choice of fans of the same size?
Photo of the "ring" etc? Plus of the complete assembly and a ref to which instructions you used would be good. Plus where you bought the V6,...
Where are you? Country that is! Possibly makes a difference as shipping a complete printer would be costly.
The diagram is very confusing as it is not clear which wires go to the coil of the relay and which go to the contacts and why you need the relay?...