Separate names with a comma.
yes it is a bit heavier, a drawback of a dual head direct drive. It is still a big improvement of the original big box design. Have not seen any...
Thanks for your post Jon! I never followed up the volcano thing, i have those hotends in a box somewhere and it should be doable without...
Do you use standby temps? It's very easy to do, you should have no problems with oozing at all with a small priming procedure at toolchange.
Hope things gets better, E20 seems to have been way to low, or? I wonder if the order of U and Z axis really matter.
Here are my FFF file and config.g (had to change file ending to .txt to be able to find it i file browser...) There are a cople of old artifacts...
I too have both my hotend fans running at full chat if hotend temperature is over say 45C just like Mark above
As I remember it, I set the standby temp for the PVA material rather low, like 150-160C without retraction still with a generous purge (some 20mm...
I've done torwell PVA support, never tried scaffold (witch is a PVA type material?) It worked ok, but I had a heck of a time to get it to stick to...
Hope you will be pleased! Is it all printed in clear HT?
I believe the switches will be fine. You don't have to use Omron brand :) As I remember, M3? (I used leftovers from my big-box parts bin. I think...
Let me know if you have problems with the parts? Mine has been running as built (without a single problem) for a long time now, most of my parts...
And this is the only support needed (if you use an IR sensor, don't print this part, this is mentioned in the first post)
support only needed for the BL-touch version carriage (under the probe area). I never got the orientation right when converting to STL's. Fusion...
Hi Shin! Mine is still running strong, just as good as it ever was.. As for the pancakes, I'd say that 1mm is no issue, the is some room for...
Maybe my view is not entirely objective, but I'm not looking back, no problems so far even with huge dual head prints. Only thing I'd reprint on...
And while you are at it Alex, you could improve my fan ducts too :)
Hm.. I hope the drive belt offset does not cause problems, otherwise I like what I see. I played around with putting a X-motor at each end too,...
Hi Alex :) I Don't believe there is a temp problem with PLA anymore, look here :)...
Must be something to do with relative and absolute distances messing up somewhere, perhaps in the slicer scripts? here is my tfree0.g anyway...
it's to do with 3,3Volt logic or 5V as I understand, if you have a late bl-touch you can cut a bit of the pcb for 3,3V logic instead of using a...