Separate names with a comma.
It is probably a copy and paste mistake from the thermistor configuration where R is the resistance.
It's probably because the magnetic base is a flexible magnet which is usually Ferrite in some kind of rubber. The Ferrite usually has a high...
Ah, indeed. I overlooked the 150C, the magnet base is only good for 140C, accounting for oscillations probably less.
Indeed. I guess it takes longer to heat. Without it it heats faster than the hotend.
Why not just keep the magnetic base attached permanently and then just put the PC sheet on that if you need it. It's just one mm thick and you...
Yes, it works well. It also heats up way faster than my previous thick aluminium plate. The only thing bad is the border is not deburred.
Indeed, Schuko: https://en.wikipedia.org/wiki/Schuko Swiss, Denmark and UK being the exceptions.
I found one magnetic spring steel plate with PEI which fits exactly on the heated bed plate. It comes with a flexible mangetic sheet which has 3M...
In the EU you can put the plug into the socket either way, and either way is right. From any device point of view the distinction between live and...
I was right at the end of commissioning, pressing the "Auto Bed Compensation" button. Then the bed moved up, but the z-switch was still outside...
This looks great. I tried the Chase IDEX but some parts were just too flimsy and broke off while assembling. Since I'm running acceleration at...
Which it is supposed to. The bed is constrained in X and Y direction by the 4 smooth rods + linear bearings. The leadscrews need to be free at one...
Thanks. I took your design and removed all unnecessary things, made it 8mm shorter on the right side, so it would print in under 2 hours per part....
Thanks to E3D for the BigBox. It is my first and only printer and I think it is a great one. Before having a 3D printer I didn't realize how...
It's still at 230400. I'll try it, thanks.
Somehow the RC7 doesn't work for me. Every couple of layers the printhead moves to the back of the printer. If it gets lucky and doesn't crash in...
My IR sensor behaved erratically too (glass bed). I removed and reattached it lots of times and finally it stays mostly consistent. I suspect the...
@R Design I'll check the voltage today. I'm using XT90 on my bike since the Anderson PowerPole melted after a month and I'm very happy with them....
It should fit with most 40mm fans, the screw holes are 6mm deep. I thought the hotend fan is already set to 12V on the RUMBA, I didn't check it,...
The fan ducts I found on thingyverse were either not so good or didn't fit with the titan carriage so I made a new one....