Separate names with a comma.
I found out the problem. My nozzle was too close to the bed and it could not extrude the filament as quickly as is wanted too.
Ok so, I reset all defaults and recalibrated everything. and it is working now...so the ol, try turning it on and off again, and recalibrate solution
The first thing that I printed was a test print to calibrate temperature for a spool of PLA. Everything worked just fine. Perfect infact. Then I...
210, everything seemed to go correctly with the 100mm calibration but when I print the extruder motor clicks and the filament slips. but only when...
Ok, this is an interesting one. I can run the calibration to do the esteps to get the proper 100mm of filament with no issues. But when I try to...
When doing the homing process is the final position supposed to land at x=150 and y=68? Those are the values given on my screen and on the picture...
Do i need to contact support directly for a problem like this? It seems like the settings may be off. All of the geared parts were corrected and i...
Ok I switched out the tooth gears with the 20 tooth on the x axis motor and the 16 on the Y axis motor. Everything is fine on my x axis with it...
Do you mean the stepper motors? All of those are correct. It stays inside the bed. It moves and contacts both X and Y stitches and raises the bed...
When I am doing the homing step to at the beginning of the commission process it runs just fine but when the auto home is done it does not end on...