Separate names with a comma.
Check that the heater cables are firmly held in the terminal block by tightening the screws and those to the power supply if its not a power...
Use only the hardened nozzle. I real of carbon filled filament will cause a lot of wear on a brass or copper nozzle and make them perform poorly....
I'm a bit mystified as to why you needed a new mother board. Your original problem was that you had a failure during a print that clogged your...
Hell of a lead time Greg; we seem to have had a lot more than a 4-start wait! :D:D
I always follow @Alex9779 initial findings and ensure that I have a cool down element in the post script. I set this to 30C and there is enough...
Cez, it is normal for the electronics fan to be on all the time power is applied because the board is active and generating heat, so use those...
So what's it like with black filament? I find a lot of difference between certain colours, e.g. white and black, due to filler composition and...
Good luck with the work Cez!
@cez first raised this on Facebook and it occurred at switch-off of her working printer and there has been a long dialogue there with no...
I missed that this was Bowden and, yes it is longer to allow for slack take-up in the Bowden tube, so stick with your 5mm.
That is not right as the hob must be central to the filament guide. I hope someone from E3D picks this up and responds.
For the V6 nozzle assembly you should keep retraction to no more than 2mm as the heat break is quite short. If it works for you OK but be aware as...
Just a long shot, I assume the printer has a Bowden tube feed from the extruder to the hotend, so what is the internal diameter of the tube, is it...
OK Paul, wear is not restricted to filled filaments but some colour fillers can increase it too; of course dependent upon the volume of printing...
That looks like nozzle wear; are you using filled filaments as I had this problem with an earlier printer using Laybrick and Woodfill.
Ensure you do a warm pull i.e. remove the filament while the nozzle is hot, as there is naturally some expansion of the filament in the hotend, so...
Ah, I see your problem . . . Fan ducts BLOW! . . .:D
Hi again! PTFE shavings will be very unwelcome in the nozzle and you are right to be concerned. With the Bowden setup it is preferable not to...
Hi Paul, As you will have seen you are not the only one. Good luck with getting a resolution from E3D.
I feel sure that this is an issue that E3D need to be involved with as there may be a quality control issue that they have not been aware of. I...