Separate names with a comma.
I have to preface this with I have a bigbox dual and no matter what I switch around the error stays the same, just trying to figure this out. I...
Is there any interest in buying mine? If so I'll post some pictures and what not.
So as the title says I can get good solid layers for the first 3 or 4 and then it stops extruding. Would that be something in the simplify3d...
OK so I set the offset correctly with the paper test and can double and triple confirm that it is consistent. I level it and make sure the...
So to give the final product of this, my raspberry pi is broken and I am awaiting a new one from amazon. The reason it is broken is because in my...
When the printer goes to the back of the printer to level it doesn't stop just bumps the back of the printer and I have to turn it off. I did a...
So I have two issues and I assume they are from the same problem (whatever that is), 1 - the printer bumps up against the back of printer...
When I do a readout for my Y-axis potentiometer it shows as 4.9 Volts. All the other ones show the correct .55 - .6 volts. How do I fix this?
When I move the printer on the y-axis the sides scrape the walls. How do I fix this?
Does the 1.1 have any upgrades from the kickstarter version or are they exactly the same?