Separate names with a comma.
In my experience of this it's not really a problem. The dump area is available to both heads and the standby head is off the bed during printing....
As I think I said before I am using an earlier version (circa 28/29 march) together with 16 tooth pulleys and the standard bearing idlers. It...
I suspect you are correct, but I was constrained by existing cable lengths and it would need a complete strip down to sort it properly (not on my...
So I have completed my build and done the initial commissioning and calibration. I used a slightly earlier version of the design so my results may...
Warming up the delta now ... :)
Was just about to report that ... but the rest of build has been OK except the hot end wiring which is tricky but that came together in the end....
Would likely be fine but shipping/duty/vat etc for shipment from the US is a pain. Would also need to resize for M3 bolts. I have started my...
Seems a good way forward, I'll take a look tomorrow. Incidentally, X-idler bearings are F604ZZ in original, Chase's, Greg's IDEX Bowden as well...
Just noticed in your draft readme that you suggest a 20 tooth gt2 pulley. This was was intended for the original 0.9 degree nema17 X motor. With...
Might want to take a look at the way Greg did the belt idlers in his Bowden IDEX - it is a very compact solution and uses 20mm M4 grubscrews self...
Mine was at 0.2 so you could be right :)
Interesting you had problems with the endstops since I have a spare e3d BigBox endstop and it seemed fine when I checked on a 'dry fit' and the...
Its looking pretty good so far, I have all the bits now to try upgrading after I take a look at the latest files! Might even be up and running by...
Had to slim down the main wall of the extruder holders - 4mm is too thick for the short Titan screws and too thin for the long ones. Settled on...
All good points, I have had a similar problem with the original Chase's dual Titan design. Currently I have implemented Greg's Bowden IDEX design...
Also consider that for dual object synced printing with both heads Z needs to be the same for both so adjusment is useful for that use case ...
I considered fitting the IR sensor to the sides but it seemed to me that this could lead to a loss of build volume so I went for fitting...
I have a remix for the IR which could be adapted ......
I have remixed the x-carriage-left-he to include mounts for the IR carrier opposite the fan mounts. It fits the extended IR carrier for Chase's...
That looks amazing! I look forward to release and upgrades to come :) I have built Chase's dual Titan X-axis and am getting some nice dual...