Separate names with a comma.
An undesirable effect I've noticed: If you stop a print from the control panel, and then start it again [as opposed to a resume], when the heads...
Don't know if you have an answer yet, but S3D is dowloaded from https://www.simplify3d.com/ You need a code from e3d if you bought it from them,...
My measurements suggested the Y deflection was about twice the X - not surprising given they carry the X load as well. Y 0.10 X 0.04 .. of...
Has anyone had any experience with this? My bed is glass+kapton, which has been fine for PLA and ABS with no glues, sprays or other condiments....
Whose profile are you using? I could never get the S3D ones to do what I wanted. Alex's ones worked fine - but having said that, I've not tried...
Admit I had the same thought :) I have a few lengths of V-Slot kicking about that I bought to experiment with. Not sure how durable the track is...
As you say, 8mm rods are probably "just enough" ~0.15mm is a fine(ish) layer height all on its own, though, so without compensation, prints...
I can report that mesh levelling does help a lot. Not ideal, to use software to compensate for a hardware shortcoming, IMO, but short of a major...
Ah, assumed the switches were NO rather than NC.
I've seen this too, though not often. I'd suspect its pickup on the microswitch inputs. The pullup seems to be on-chip, and in the "20k-50k"...
Thanks muchly. Sterling work with the firmware!
Torque for a stepper falls as speed increases, so if your manual drive is slower than than auto, it's possible..
New firmware in. Mesh levelling numbers seem to match the ones I get by measuring, and having finally got the PLA to stick, printing in progress....
Thanks
A bit of a guess, but it's not the umbilical for the heads not wanting to bend so tightly? I imagine that could provide a small force away from...
This firmware, I guess: https://jenkins.alitecs.de/job/BigBox_Geek/branch/BigBox%252FDual%252FRC_Hybrid_Titan_MBL/
I hadn't expected total flatness, but I have to admit that the magnitude I'm measuring is a bit larger than I expected. I'm on stock firmware -...
Just built myself a fitting for a travel gauge I had to level the bed. The levelling part is easy enough now... But, I'm noticing that the bed...
pretty sure it is, but I'll go over that again
More testing - a sheet of black paper under the glass causes proper triggering. PCB too shiny?