Separate names with a comma.
If you don't end up getting your pull request accepted, you might want to submit the request to SuperSlicer to see if they will accept it instead....
Yeah, I have a prusa slicer profile for exactly this scenario. Prusa Slicer gives off a fan speed per tool swap so its a bit easier in this...
Not as far as I'm aware. You could probably fix it in S3D in the scripting tab but IMO you don't really need it. PrusaSlicer does the same thing,...
I'll give it a test as soon as I can. I have been distracted building a shapeoko enclosure. As for S3D: You place it in the toolchange scripts tab.
I don't know exactly how the duet firmware handles it but here are two potential differences between your tool change scripts and mine: 1- I...
[IMG] Nothing against scaffolding but if you print mostly PETG you will love the fact that PLA doesn't stick to it well. Its an amazing support...
I had some weird problems with toolchanges after a certain duet firmware update. I'm not sure why it started happening but it's possible it was my...
I'll give it a shot later today and see if I notice anything. I had been dealing with some surface artifacting a few months ago that i was able to...
Is there a reason the hemera runs at 32 vs 16 for the titans? I run all of mine at 16 and it seems like the loudest part of the entire hemera tool...
This is really interesting stuff, this is something I wanted to tackle at some point and I just haven't had the time to really look into it. I...
Back in August I purchased a 300mmx300mm sheet of PEI off of amazon and then just cut it to the size of my glass bed. I mostly print PETG and it...
This is awesome. How is the quality when printing at high speeds? The only thing I didn't like about mounting the hemera on on my TC is the added...
I can't speak for the precision of the BLtouch, but the button is pretty good on its own. I usually set my relative tool heights with a dial...
I'm not sure if there is an updated list. There is some older documentation about what placeholders can be used and when but nothing that appears...
A self reply instead of an edit for an important note about setting temperature in the start Gcode that I had forgotten. PrusaSlicer will still...
[IMG] I use this. Custom Start G-code in the filament tab is called every time the slicer swaps filaments internally. So I use this as both the...
Yes, The entire extruder is much quieter than the old titan bowden setup. So quiet that I didn't believe believe that the extruder motor was...
I had no idea that the BCN Sigma was open source, so I went to their github and started looking through their code. There are a lot of interesting...
Yeah, that's a harder problem. Another idea I had was to try and count the filament usage similarly to how the duet's web interface does. I wonder...
I was thinking about a way to to preheat a hotend in advance prior to a filament swap and had the idea of writing a post processor that reads...