Separate names with a comma.
Heh, yeah, I chopped off the end rings exactly like that just after I posted my photos. For folks who haven't tried it, the default purge...
That's where I started, the supplied design does not seem to work on the other side, the tool head cannot reach it due to the PCF being in the...
After discussion about setting the standby temperature for the idle toolheads, the thing I want to do is pre-heat them 'just in time'. Is anyone...
First, I haven't seen any mention of them, so here's what I needed to do to set up a tool-head with a Volcano block & nozzle: Subtact 8.5 mm from...
My panels seem a bit more stable now; they haven't developed any more cracks while sitting outside the printer, after I wiped them down with...
I don't have the time to work on the re-design, but I'd definitely prefer (alternative?) models that use heat-set inserts.
I hadn't though, at least not on obvious interfaces; I only used it for the M8 bolts on the extrusions. All of the acryilc/threadlock interaction...
At least I know how fast the isopropyl evaporates... anyone know how long the 242 takes to completely evaporate the solvent, and/or otherwise...
I had threadlock (blue Loctite 242) attack my acrylic a different way -- I've used undoubtedly too much, and had it squeeze out around the ends of...
Regarding the original specified rods, Misumi USA has a site where it's trivial to order rod stock cut to precise length. I think you can just...
What am I looking at? Square neodymium magnet with a hole in it? Seems like a nice screw retainer. I also found I can use a magnet to move the...
Greg, be aware that the Pi Zero is underpowered for OctoPrint (I'm familiar with them in general, but also played around specifically with the...
This is the first thing I've built with a significant number of t-nuts in vertical extrusions, and I'm finding them mildly aggravating... assuming...