Separate names with a comma.
Page 6 of the datasheet lists the colours. You may also find this guide useful.
Does the Z-axis move as expected when not printing, i.e. when controlled via the TFT screen or over USB?
Appreciate this turned out to be a current setting, but I agree with this. I tend to use lower tension than the guide suggests. I recommend...
Enabling Z-hop may help prevent dragging, but I agree that it’s worth trying to identify the underlying cause.
Sorry ‘correct’ was a bad choice of word. Lol. I meant are they set as you expect as it can be easy to forget you’ve changed something when...
Can you confirm that your printer and slicer are configured correctly? I know this is difficult, but have you updated the firmware according to...
I'm unsure if this will help, but I've posted a follow up to explain how I managed to overcome clogging with TPU and the settings I used.
I recently installed a Hemera onto my Sidewinder X1. As per the instructions I updated the firmware, adjusted the VREF and performed PID tuning....
@Danny Baughan did you resolve this? Just curious to know if you tried slowing the print speed down to something like 30 mm/s or even 20 mm/s?...
Interesting. Would you say it is a lot noisier? Did you adjust the VREF to about 90%? Does it sound like the noise is coming from the motor or the...
It technically could e.g. if the VREF was too low and the motor didn't have enough power to push the filament though, but there are a number of...
Do you mean compared to using the Hemera without adjusting the VREF from the stock value (0.982V)? If so, I'm afraid I didn't try that. I...
You are welcome. This helpful TMC2100 guide explains how to adjust the VREF. I’m afraid I do not have any pictures but the stepper driver I had...
I am not familiar with the TMC2209 but if the calculation is the same as the TMC2100 calculation 0.94 RMS (1.33 VREF) would be the maximum for the...
Following a bit more research I think I have found the answer. I'll share it here as it might help others. The Hemera's Motor Max Current rating...
The stock Artillery Sidewinder X1 (EVNOVO) extruder motor has a model number of 17HS4023S-23. According to this page which lists a motor with a...
Does anyone happen to know which stepper drivers the Artillery Sidewinder X1 (EVNOVO) uses? The firmware source code appears to suggest it uses...