Separate names with a comma.
I have mine set to+9 and -9 works fine.
And now the Chimera gets done http://www.ebay.co.uk/itm/RepRap-3D-Printer-Dual-Input-Dual-Nozzle-Bowden-Extruder-HotEnd-0-4mm-1-75mm-/121704584458
Another blatant copy...
After some searching this looks like the ideal stuff http://www.cotronics.com/vo/cotr/pdf/920%20DS%20NP.pdf just need to find a supplier.
Good feedback, I will keep looking then. Though as I will be buying this in the UK from a UK supplier our trading standards laws would make such...
Thanks for the feedback, I was getting my Cs and Fs mixed up. How about this stuff?...
Update time. I still like the idea of these units but I have had a couple of failures as the wires are very delicate and they tend to break where...
The Chimera is effectively two separate hot ends so what ever works with a standard E3DV6 should work for the Chimera.
As I have a 12v system, I couldn't get it to go beyond 276. Kept it there for an hour with no visible ill effects. The PTFE covered wires do not...
No just hooked it directly to a spare rail on my 12V power supply. As I mentioned I only used one so it is 6W.
The PTFE is on the leads outside the assembly and subject to ambient temperature so I doubt that the specs will be exceeded in actual use. The...
I have just fitted ONE of these...
According to the supplier they are rated to 300 degrees, time will tell. I have fitted a couple to my Chimera and so far they are working well and...
I think it looks like a jam waiting to happen, it would be a nightmare to unblock.
Probably just needs a good clean. I haven't yet tried the cleaning filament that they sell here but am considering getting some for just this...
You may have noticed my use of £ pricing, I am in the UK so looked at the E3D site, no stock :-(
I think that one would count as passing off
Fair points but for two things, 1 it is less than a tenth of the cost of the PT100 and 2 you are out of stock :-( Seriously I take the point but...
I find the current thermistor setup very fiddly, probably due to my fat fingers. This looks like it could be a good alternative if it fits into...
me being a NOOB, I haven't touched the retraction settings. What do you suggest as a good starting point.