Separate names with a comma.
All good info- Not sure if I mentioned it before but when I tried to use SpreadCylce the prints were just as bad if not worse. However I only...
I guess I have to slightly disagree there. I understand what you are implying however I don't think the Hemera is so precise the extrusions are...
Thank you for chiming in - I will have to look over the information you linked. I have tried turning off stealth chop on the extruder and there...
Well I have went through all I can think of to fix the issue. Seems like the Hermes / Hemera is not going to produce print quality that some other...
Gato I noticed in your config you turned off stealth chop for the extruder. I have left mine active. Did you see improved print quality on the...
The Good: Well I have successfully swapped the board over to the SKR 1.4 Turbo and slashed my way through making the firmware in Marlin 2.0 for...
Sort of what I was thinking but hoping not. I ordered a SKR 1.4 board / TMC 2209 drivers just hope I can figure out the firmware. :) I am a...
The mini rambo board only have A4982 drivers. I don't think stealth chop is an option for this board. It's max is 16x micro stepping not many...
I do not doubt that swapping drivers would help;unfortunately unless I change the board out , which I am thinking about doing, I don't have a way...
Video and some more pics of things. Did a temp tower at the moment but I will do something different and make a small video of that as well once...
First off thank you for all the help and trying to decipher the possible issues. I honestly appreciate it. Now onto the list! 1- I really can't...
In regards to the change in the print , that was just temps and speed. I was playing with cold vs. hot at different speeds. Not really much change...
Well definitely not the daughter driver board. I swapped the steppers back to the mini Rambo taking the daughter board out of the equation. It did...
I've tried so much at this point I have forgotten where I started and what I've done lol. Short answer is no I never did resolve the uneven...
https://drive.google.com/folderview?id=10-EKAV6_48PUKxXClPZhZJ6PpL7r2iiN
Well been trying a few more test this evening. This is a 100mm circle printed at .2 layer height and 60mm a sec for 3/4 and 100mm a sec for the...
The tube is Capricorn PTFE , it's just a brown color, was intended to be orange but came out brown and was reasonable priced so that's why the...
It is now, that was the only thing left mechanically to change. I had it handy and it was brand new, however 99% of the testing etc was with the...
Still having the same issue before I took the extruder apart. Everything looked fine from what I could see. Gears seemed to be one piece....
This was at .87 extrusion multiplier and 20mms no change at all to be honest. At this point I am thinking something mechanical with the extruder...