Separate names with a comma.
thanks! Do you have files for both ends of the Y rods (this is the part that holds the motors for X) My belts dont hold in those parts either.
Gonzalo, I would be interested in any/all of the STL files you have for your extruded setup. I may wish to do this! I've been struggling with...
I tend to work best with pictures and labels. But yes, please and thank you for any help. I _had_ my bigbox dialed in pretty good with just the...
Andy, I was wondering if you have any details on the wiring setup and configs for the DuetWifi with IDEX? I'm stuck at the point of wiring it all up.
It's the electronics wiring that has me stopped at the moment. I have no clear direction. That's why I asked for others that DID do this IDEX for...
I'm truly debating if I should revert back to single extruder, original rods and my DuetWifi. I fear that If I didnt wire up the duet add-on and...
Julian, I'm still working on mine. I'm trying to verify my electrical wiring for the DuetWifi and Duet5. Prior to IDEX i was running very...
Any update for IDEX in your DuetWifi post?
I'm trying to revisit my IDEX. nearly all done with the build phase. History; previous rock solid DuetWifi with Titans. I removed the entire...
Update: not much really. I've had to step away from the bigbox due to other projects. Now those are finished and I'm needing to get back into...
OMG! This is fantastic! If only someone would also add the IDEX section. Duetwifi/Duex5 + IDEX = new life back into the BigBox ! #DIDEX
My update: I have all the mechanical assembled and sliding. I'm slowly working on the wiring. I had the Duetwifi running before I made the swap,...
I made a fix. It requires 9 small washers. Make three stacks each with 3 washers. Use these between the Titan backside and the carriage. Your...
I found an issue with my IDEX left side carriage. I'm hoping someone has a solution; probably a reprint! haha! See pic: The belt from from the...
So I've had another hard stop. The left and right side GT2 belts of the original Bigbox X carriage are just not long enough when using the...
I forgot about that feature. I'll have to go check to see if that's still possible. Moving the boards back a bit, sacrifices the middle support...
I've had to halt my upgrade to IDEX. my fault, but since I setup one carriage with the molex connector, none of my wires are long enough to reach...
OK, I now have my Duex5 sitting along side me DuetWifi on the BigBox floor board. I'm not sure how to wire this thing up. Anyone have a...
I've got my DuetX5 on order... How do I mount the DuetX5 n the BigBox? My DuetWifi is already mounted and running fine.
Please elaborate on How to have 2 separate Z motor and side to side leveling (config files too?). Also, How would 3 z motors work? details please....