Separate names with a comma.
Does anyone know where I can find replacement stepper motors for the 42BYGHM809 Wantai motors? I have been looking online and cannot seem to find...
The SMD version, I believe.
While I am glad that I ordered a new sensor, I did finally manage to get it to work with the Buildtak. It took quite a bit of trial and error...
Couldn't hurt. At this point all options are good options.
I tried without glue and with a heavy coating of glue and the results were the same on bare glass. The height map was looking like there were...
Sorry to be a pain, but I have a question... I was getting very bad reading from the sensor on the glass bed due to sagging (even with the...
@Spoon Unit You helped me solved it. When you said the sensor was to the right "(really)", it made me realize that I had that backwards. The...
G1 X0 Y0 was not sitting at 0,0 so I changed the config. M208 X300 Y245 Z295 M208 X1 Y1 Z-0.2 S1 G31 X60.0 Y15.0 Z0.75 P500 Mesh is set...
I wish I had an answer for you, but I had the exact same issue. After about a month of trying to figure it out and reflashing the board countless...
I understand, but why would they have changed? My existing S3D scripts have worked fine for hundreds of prints on the Rumba. I guess my real...
I am very close now with only one (I believe) issue left. I am going to post snippets of my code if that will help: ; Mesh Bed Leveling Macro...
After a hotend mishap by having the fans reversed and causing a massive clog, I have the printerand the duet about 90% configured. Howvwer, I...
Well sh$t...... Guess I should do that then... lol Yes, I did just upgrade to 1.19. Thank you!!
Could someone please share their homex, homey, homez and homeall .g files for a Titan Pro (Single Extruder)? The reason I am asking is that all...
I get it!! Just cap them off, shove them to the side and get on with my day. So simple. Thank you!!!
I am trying not to take the entire top off and so far I have been able to work fine through the fan opening with the LCD removed, just sayin'. So...
I have a really "dumb" question. I am wiring up the DuetWifi. I labeled all of the wires as I took them off the Rumba. On the Rumba there are...
I thought I would post an update. I have a working printer!!!!! After many back and forth emails with John and Greg at E3D we finally came up...
So I have been doing a lot of testing. I thought this might be due to a bad IR Sensor, but if I lower the bed and then raise the bed and place a...
That is where I started, but even trying to set the z offset to -5 did not work as it will only go to -4mm. I'll see what I can do when I get...