Separate names with a comma.
mmm, yes following the e-step calibration guide, marked at 12cm and the mark when 'missing', so I marked 14cm, and I printer 15.5cm.... thats no...
Here is what I did tonight, limited time.. Dropped extrusion down to 0.85 was 0.95 Slowed the 1st layer speed down to 25 Increased distance to...
I've taken the manufacturers calibration on the e-steps, it seems like when I print a large say 5 x 5 cm 1st layer diagonally, the first say 10...
Just trird some hair spray, maybe about 30% better... still no good
All the other issues are ok, this is the remaining one. The first layer.... a solid first layer like this does not help, I'm trying a few things,...
Hi guys, Been away for a few days, Ok so it seem the white filament was the problem as the new gray one was better, yet the issue continued so I...
G'day all, Here is tonight print, not to bad if you don't consider the top block. Well once I get the fillament to stick to the glass bed. O boy...
thanks mate, I fixed the type, it's just where I ended up after weeks of trouble shooting. I'll bring the multiplier down to 0.95 and back to my...
Ok so it's not perfect. Two very important things to note here. 1.) The feeder did not 'flick' back, not once. 2.) the color is different... yes...
I've set the voltage to 0.6 of a volt, when I do a 100mm extraction it runs through just fine, when I loosen the pressure adjuster between the...
Hi all, So many thanks for all the comment and suggestions, they have all helped me so far and I have learned heaps, Great stuff TOP Forum. I've...
Hi all, So I've done most of the above, stripped it all down and rebuilt including thermal past and all, There was a little bit of play in the...
Thanks again for the advise will try them all one by one. Here is a pic of the fillament[ATTACH]
Hi all, So i've dropped the temp down to 190 and still the same issue, it seems like it mostly happens when it's filling in bigger flat surfaces...
Thanks all, I'll try this tonight, I did do this. Cleared and re inserted the filament, extruded a 100mm and it ran through smoothly! took a...
Hi all, My filament is getting stuck in the extruder after about 5 - 10 minutes of printing. The only way to undo it is to heat the head up, and...
I have a similar issues with the E3D, and it's pretty much brand new, it will print fine for 10 seconds, then the extruded filament drops, then it...