Separate names with a comma.
This one is not the same switch, it runs but has not the same terminals for solder (just wires): D2HW-C202M In my case, the TC comes with this:...
Wow, it's impressive. I allways had belive this is can only octoprint.
You put directly to the heated bed or stick it on the glass? If I do this directly on bed, I can't warm up the bed to 200 degrees. (I'm not sure...
Ohh, I read again the code, It's a lot easyer if I do this in the "Tfree1.g" than at slicer. Thanks! We need this like a tutorial, or Pinned at...
I have some good results on my own "trash" code, I insert this in the tool changer section: In my case, I have a original E3D toolchanger with T0...
Thanks for example, so...I understand that for each tool you make a separate brush/purge macro... and this is executed depend on the tool is used...
At duet2 I use the follow code: M569 P4 S0 The key is the "S", 0 means it rotate normal, and "1" it rotate reverse. In my case, P4 it indicates...
Thanks. It cost about 60€ in Europe. not really cheap...
From Where you get this beatifull textured bed?
If you speed it up, you need more temperature. What material are you printing and what temperature are we talking?