Separate names with a comma.
Anyone looked at the Jubilee project (https://github.com/machineagency/jubilee/wiki)? It appears to use many of the E3D ideas (with some nice...
I'm guessing that others who paid a deposit have seen the email with the latest news. Am I the only one who was shocked by the current estimated...
1.1.8? If so, make sure Z_MIN_PROBE_REPEATABILITY_TEST is enabled and run a M48 to see how repeatable your probe is. I ran this on my Bigbox...
It should be on the LCD startup image. I'm guessing by the fact that you are asking means you haven't modified the firmware since getting the...
What firmware version are you using? I found a similar issue in the past and it appeared to be linked to the offset being "forgotten" or not...
It would certainly be good to have a write up for the community. I've thought a few times about doing this mod myself but have to admit that at...
Excellent work! I've wanted to figure all of this out myself for some time. In many ways I prefer how Slic3r controls the profiles but this will...
I'm in. Basically this is what I had started to design for my Bigbox, but I dont have anything like the time E3d have spent on development and I...
Sorry, I've not had the time to creat a github fork - not done that before so would need to investigate. I can report that 1.1.8 appears to be...
Depending on the price I might still be interested in a pair if you are collecting names.
@Greg Holloway - what precision and pre-load options did you select? I would prefer to use options which have already been proven.
Ok - I'm just collecting ideas for my next update. X-Y is the priority for me though - my Z isn't too bad to be fare.
Nice! @Ephemeris what are you doing with the other 4 pairs? Depending on the price, I might be interested in a pair.
I've done some printing this weekend. I've turned linear advance on. To be honest, the calibration code showed a definite difference and that a...
I enabled linear advance last night and calibrated the K factor (55 if you are interested) but haven't had a chance to run a test print with it...
So I thought I would spend a few hours today playing with Marlin. I have been using @Alex9779 1.1.0-RC6 BBDual for over 18 months (wow - I...
I think you will need to provide a lot more information. It sounds like you have dual extruders and neither work? Are you saying the extruder...
I print Petg all the time and never get lifting. UHU on glass and bed at 80C (possibly excessively hot but I've never tried to tune it as it just...
After using the M500 to store the settings, my nozzle sits on the bed and reports zero. It is interesting how it moves there though. It slowly...
I have installed a limit switch. I have it triggering about 1mm above the bed surface. I then use the mesh bed leveling to zero the nozzle to...