Separate names with a comma.
I recently treated myself to a black Alu/PEI bed from Clever3D, and finally had a chance to try some prints with it, however so far my experience...
I'm developing a bit of a love-hate relationship with my BigBox. A pattern is emerging where it will work quite nicely for a while and then...
I've been getting some nice single nozzle prints out of my BigBox and decided it's time to move on to try dual extrusion. However I'm finding it...
I'm trying to assemble some Volcano heat blocks which came with my BigBox, using some additional 40W heater cartridges I purchased separately...
I've been printing some replacement hybrid carriage parts in Edge today and I'm really impressed with how they turned out. These were printed at...
Despite having a 1.1 BigBox which comes with a damper for the Y axis motor, I found I was still getting some vibration from the Y axis which...
So although my BigBox is generally working well, while trying to fine tune my extrusion multiplier I noticed some very small artefacts in the Y...
I've been using OctoPrint for a while on my old printer, which like the BigBox has the Pi running off a stepdown convertor to supply 5V to the Pi...
Has anyone got any hints on how to get the thin walled PTFE feed tube for the direct Titan on the hybrid carriage inside the end of the Titan...
So, everything has been going swimmingly with my BB build (well, apart from having far too little time to work on it...) and I'm in the midst of...
I'm at the point where I'm connecting up the LCD, and I'm a little confused. The instructions say to remove the connectors from the LCD PCB and...
I wasn't quite sure where to post this, as it's not quite a mod and I didn't make it on a BigBox either, but it is FOR my BigBox, so.... here it...
I haven't received my BigBox yet, but I've purchased a PEI sheet to install on the glass as I'd really like to get away from the hassle and mess...