blocked

  1. Quentin Spottiswoode
    Thread

    Cyclops+ Jamming

    I have just installed a cyclops+ Hot end on my CR10 with duet wifi, Set-up my RepRap firmware and drove a little filament through both sides...
    Thread by: Quentin Spottiswoode, Oct 31, 2021, 0 replies, in forum: HotEnds & Extruders
  2. vanthios
    Thread

    E3D-v6 Won't Even Extrude More Than Once! HELP!

    I've been trying to fix up an old Makerfarm Prusa i3v that I abandoned a few years ago for a similar issue with constant jamming. I've used my...
    Thread by: vanthios, Jul 21, 2017, 8 replies, in forum: E3D-v6 and Lite6
Showing results 1 to 2 of 2