Separate names with a comma.
Hi I am trying to calibrate a newly built ToolChanger and I am slowly getting there. After getting a pretty good first layer with z calibration I...
I've just had a really frustrating and puzzling experience. The part I have just printed is one half of a puzzle cube and should be 100 x 100 x...
I've just started printing the benchy document to calibrate the new printer, however every time I try printing, after the first few layers, the...
I plan on installing the PT100 Amplifier board on the X carriage of my RigidBot. This leaves quite a distance of wire between the Thermocouple...
Ok, first, I looked all over for these details, but have not seen these questions answered specifically. Hope I did not miss it. Feels so close...
Hello all, So, I got BB all put together, figured out how to flash the firmware from another thread on here, so now the dial turns the right way...
I have a bix box dual and have been getting wavy lines on both axis but it is really noticeable on the Y. Does anyone know what could be causing...
Hi I've been playing around trying to get my prints to work - realising that print surface being perfectly flat is the key to successful and good...
So I'm in the final stages of assembling my Pro. I'm currently stuck on the z-axis calibration step. After choosing "Move Axis" -> "0.1mm" ->...
The manual says to the z-axis calibration: Via the menus run the bed all the way down to the bottom. [IMG] I can move the bed to position Z:...
I am having consistent problems with this printer remembering its z calibration after it has been powered down. Almost every time I start it up...
Hi, I'm totally new to 3D-Printing and the BigBox is my first 3D-Printer. Now I'm stuck at the point of calibrating the Z Offset. I've follow the...
So I just got to the point of Calibrating Z Offset, and when I do auto home, this happens: Failed Auto Home Can someone tell me what is wrong?...
I've just performed the extruder calibration before I do my first print, however it seems way off what is should be. Firmware default is 304,...
Hey, The guide is a bit lacking (or I have missed it) on how to configured the Z endstop on a dual printer? The guide has all the info for the...
I have just turned on my factory assembled bigbox pro. I followed the instructions for first print from the manual but the filament feed seems to...
