clogging

  1. Quentin Spottiswoode
    Thread

    Cyclops+ Jamming

    I have just installed a cyclops+ Hot end on my CR10 with duet wifi, Set-up my RepRap firmware and drove a little filament through both sides...
    Thread by: Quentin Spottiswoode, Oct 31, 2021, 0 replies, in forum: HotEnds & Extruders
  2. Liviu
    Thread

    V6 clogs PLA - Ender 3 pro

    Hello, I am starting to have terrible issues with v6 extrusion on an Ender 3 pro with skr e3 mini v2 and Bowden setup with Creality all metal...
    Thread by: Liviu, Jun 29, 2020, 2 replies, in forum: E3D-v6 and Lite6
Showing results 1 to 2 of 2