cyclops blockage

  1. Quentin Spottiswoode
    Thread

    Cyclops+ Jamming

    I have just installed a cyclops+ Hot end on my CR10 with duet wifi, Set-up my RepRap firmware and drove a little filament through both sides...
    Thread by: Quentin Spottiswoode, Oct 31, 2021, 0 replies, in forum: HotEnds & Extruders
  2. RURC
    Thread

    Cyclops issue will not extrude from one side

    OK guys I am an intermediate 3D guy. My son is a much higher intermediate guy than I. We are both about to have lasers come out our eyes. We...
    Thread by: RURC, Jun 8, 2016, 9 replies, in forum: Multi-Extrusion
  3. iamflimflam1
    Thread

    Clearing Cyclops hotend

    Hi All, I've got a Cyclops hotend which is only working on one side, I think the other side is blocked. Any suggestions on how to unblock it?...
    Thread by: iamflimflam1, May 7, 2016, 2 replies, in forum: Multi-Extrusion
Showing results 1 to 3 of 3