Separate names with a comma.
Hello all, I have a delta Kossel clone running a Titan extruder to a Bowden V6 hotend that is consistently grinding filament even when extruding...
Seems i've finally run into a problem big enough to make an account here and not just rely on /r/3d_printing for a quick fix. I got an old, beat...
Hello friends, I am trying to make my own E3D v6 heat sink. The material is made of aluminium. I would like to know what kind of coating is used...
Hello all! I'm sure this has been mentioned a number of times, but reading through some of these didn't seem to EXACTLY hit the mark on what I...
I have the following configuration on my CR-10: - Titan extruder with full size motor (was inside the E3D kit) - 45cm Capricorn XS PTFE Bowden...
I'm having a problem with the infill and top layer in my 3d prints. I did a test with 95% infill rectilinear, and the infill is inconsistent....
Hello All, Thought I would share my modification of my Flashforge Creator Pro X/Y carriage to accept an E3D hot end. I first printed the parts...
If I want to upgrade my E3D v6 Lite to V6, what parts do I need?
I've been using the V6-Lite for about 6 months and it's been performing for me without a problem up until now. Unfortunately I can't finish a...
So, Story time. I own a now defunct e3d-BigBox, and after deciding to re-tram the x/y axis, I tore appart the V6 to do the block and sock...
E3D V6 05/11/2015 Complete Heatsink/Heatbreak/Hotend/heater/thermistor and 0.4mm nozzle - has worked well, good solid prints, no extruder...
I ordered a 12 volt V6 kit a few days back and Installed it on my printer yesterday. When I set the temp to 230 degrees see, the heater cartridge...
Hi all, I'm hoping you'll be able to shed some light onto an issue I've been having - regardless of temperature setting, my V6 heating slows...
