Separate names with a comma.
Hello all, I own a TEVO Little Monster printer that's been quite happily pushing out print after print for about a year and a half now. As stock,...
I ordered a 12 volt V6 kit a few days back and Installed it on my printer yesterday. When I set the temp to 230 degrees see, the heater cartridge...
Hello, The heater cartridge of my e3d v6 was broken and I needed to replace it. As you know there is an inbus screw holding the heater cartridge...
Hello Guys, since last Week i got a Problem with my Heater (I think it is the Nozzle). The Temperature run away (Heater ID 0) if i print...
I am using the Volcano, printing with 1mm nozzle, 0.4mm Layers, And NO FANs. But I am still getting a thermal runaway!? I am using the Volcano to...