Separate names with a comma.
Hi, I got the hemera last year but because of time and problems unrelated to the hemera I never got it working. The problem I had at that point...
Good morning everyone, My Hemera always showed extrusion errors, probably caused by heat creep. It might work fine on an open frame build, but as...
Hi, Does anyone have detailed settings for their Hemera with PETG that doesn't produce terrible stringing? Looking at Retraction length, Speed,...
My E3D Hemera stopped extruding last week. I noticed the middle gear of the drive train is not moving. So I disassembled it. It turned out the...
I'm strongly considering a Toolchanger. But the shopping is a bit confusing. Coming from an MK3S, I think I want direct drive extruders? Are the...
My hemera extruder that I bought from e3d has stopped producing quality prints. I am using a modified cr 10s 5 that has a duet 2 wifi, bltouch and...
Hello everyone, i made a new fan shroud for the Hemera, which i use in my ToolChanger. https://www.thingiverse.com/thing:4494858 [ATTACH]...
So hemera is doing this wierd thing on my CR10s pro... This is a 200mm extrude and it is on speed. This thing flies. I did nothing in the software...
I have recently posted a new design for an x-carriage to mount the Hemera on a printer with 8 mm guide rods about 46 mm apart, typical of an Anet...
I am newbie but wanted wanted to upgrade to Hemera. I have everything physical done and it is working. Now to the flashing. I was going to...
I am running a duet 2 wifi and hemera dd kit on my ender 3 pro everything works but when you tell the hemera to extrude it retracts and when told...
I have an Ender 5 with an MKS Gen L board and am going through the process of installing my new Hemera. The cables supplied don't seem long enough...
Hello there, I own a brandnew hemera direct drive extruder. [ATTACH] And I have those parts: [ATTACH] The combination of these components will...
@Greg Holloway , is the Hemera stepper motor a basic Nema17 stepper motor with custom endplates and a custom drive gear? If yes, then using a...
I've just installed my Hemera (24V) direct extruder. I'm currently attempting to perform the PID tune on it and the PID autotune times out due to...
my printer begins to heat up, reaches about 189 (I was going for 200) and then begins to drop. it starts to go back up slowly and then throws an...
[ATTACH] Further details will be announced on the Duet3D forum. Availability will be limited initially, but we'll manufacture a larger batch in...
Tpu jams just like everyone else is reporting above the extruder gears shortly after starting a print. Firmware has been updated, vref set at .5,...
I have installed the Hemera on my Ender 5 Pro. Physical install and wiring went fine. Wiring: The stock creality E Stepper (see image below) and...
Hello guys, i need your help. Today i have installed Hemera with BLTouch on my Ender. During extrusion BLTouch randomly deploy and stows probe. I...