hotend temp

  1. Paul Kramer
    Thread

    Felix 3D & E3D Titan Aero

    I added a Titan Aero to my Felix 3D Printer. But I have a Problem The Hot-End temperature rises very slow. The Firmware settings of E3D are done...
    Thread by: Paul Kramer, May 7, 2018, 3 replies, in forum: Titan
  2. PikoTing
    Thread

    Heater heat up but cannot reach to the temperature (2 to 5 degree below)

    Hi all So I just install a e3d v6 into my Boxzy printer. After I update the Repetier-firmware and PID autotune it, I can still print PLA, but I...
    Thread by: PikoTing, Jan 30, 2018, 0 replies, in forum: E3D-v6 and Lite6
Showing results 1 to 2 of 2