Separate names with a comma.
My hemera+volcano was printing great for about a year. About a month ago I changed the nozzle from 0.4 to 0.6 and it continued to print great for...
I have just installed a cyclops+ Hot end on my CR10 with duet wifi, Set-up my RepRap firmware and drove a little filament through both sides...
I recently installed a genuine e3d volcano hotend on my ender 3 w/ skr mini 1.2, EZR struder, a bowden tube and a 0.6mm nozzle X. I have it...
Tpu jams just like everyone else is reporting above the extruder gears shortly after starting a print. Firmware has been updated, vref set at .5,...
Just some information to preface the issue- so I don't get generic troubleshooting responses. I purchased 5 HEMERA upgrades for my four Ender 3's...
Hi, I recently upgraded my Wanhao i3 to use a v6 with the titan Aero heatsink/extruder, but I'm getting lots of jams printing PLA. I'm trying to...
I have an E3D-V6 hotend with a Bulldog XL extruder. And I have issues with it unfortunately. The first layer or so it prints fine, looks good....
This is a first for me, but I'm guessing others may have had this, and have some way of dealing with it. I'm trying to sort out issues with one of...
My E3Dv6 has started having issues on retracts lately, after working flawlessly for months, and I cannot for the life of me figure out why....
Hi all, So I have had my E3Dv6 for a couple of weeks now, and it has worked pretty well on larger prints with PLA and ABS. The problems happen...