pla

Thread

Hi, I've just calibrated my Big Box printer to use both extruders. I'm using PVA and PLA filament but I'm struggling to find the right settings to...

Thread by: Jared Manley, Jun 2, 2017, 0 replies, in forum: Calibration, Help, and Troubleshooting

Thread

I have printed a Stegosaurus for a friend (https://www.thingiverse.com/thing:133660). It has been printed with Glow-In-The-Dark PLA and supported...

Thread by: Greg Holloway, Mar 25, 2017, 9 replies, in forum: Show off

Thread

Hey Everyone, have been trying to print the model below but for some reason the blobs and zits are very noticeable on this. Looking at the...

Thread by: Pierce, Feb 10, 2017, 4 replies, in forum: Calibration, Help, and Troubleshooting

Thread

Hi, I just installed the E3D V6 Full with Titan direct extruder with the 42BYGHM208P4.5-15-X2 stepper motor on my 3D printer. I would like to ask...

Thread by: nkef, Jan 16, 2017, 1 replies, in forum: E3D-v6 and Lite6

Thread

Starting to calibrate and optimize my Big Box, Just thought I'd take a poll and see how fast everyone is running while printing. Mine: PLA/ABS...

Thread by: goose117, Mar 9, 2016, 2 replies, in forum: BigBox General Chat

Thread

Hi All, Iv just got my volcano up and running and im pretty impressed so far. My only issue is after retracting there is sometime, but not...

Thread by: Andrew Willenbrook, Feb 14, 2016, 2 replies, in forum: Volcano

Thread

Hi all, amidst a very productive printing session, that dxxxed PLA filament from some amazonic source got stuck in my hotend, well, in my...

Thread by: UlrichKliegis, Dec 31, 2015, 7 replies, in forum: E3D-v6 and Lite6