print quality

  1. Tony MacDonald
    Thread

    Simplify 3D Settings for Hemera Direct Drive setup and standard hot end...

    I recently installed my new Hemera direct drive with the standard hot end on my CR-10S The mount I used is here:...
    Thread by: Tony MacDonald, Dec 14, 2019, 2 replies, in forum: HotEnds & Extruders
  2. mhe
    Thread

    Idea: Carbon fiber rods for gantry

    Hi folks, just stumbled across a vid of somebody testing ripple and backlash with different kinds of rods for the gantry at the same...
    Thread by: mhe, Jan 1, 2018, 11 replies, in forum: Guides, Mods, and Upgrades
  3. Paul Winter
    Thread

    Nozzle diameters, print quality problems, underextrusion, and extruder grinding

    E3D V6 05/11/2015 Complete Heatsink/Heatbreak/Hotend/heater/thermistor and 0.4mm nozzle - has worked well, good solid prints, no extruder...
    Thread by: Paul Winter, May 6, 2017, 23 replies, in forum: E3D-v6 and Lite6
  4. Pierce
    Thread

    Zits and blobs - what are you retraction settings?

    Hey Everyone, have been trying to print the model below but for some reason the blobs and zits are very noticeable on this. Looking at the...
    Thread by: Pierce, Feb 10, 2017, 4 replies, in forum: Calibration, Help, and Troubleshooting
Showing results 1 to 4 of 4