sidewinder

  1. Keo
    Thread

    Hemera wont reach 200 on Sidewinder X1

    my printer begins to heat up, reaches about 189 (I was going for 200) and then begins to drop. it starts to go back up slowly and then throws an...
    Thread by: Keo, Feb 9, 2020, 1 replies, in forum: Troubleshooting
  2. johny
    Thread

    SOLVED Hemera VREF setting for Sidewinder X1

    Does anyone happen to know which stepper drivers the Artillery Sidewinder X1 (EVNOVO) uses? The firmware source code appears to suggest it uses...
    Thread by: johny, Jan 20, 2020, 13 replies, in forum: HotEnds & Extruders
Showing results 1 to 2 of 2