titan extruder

  1. Nazrim
    Thread

    Titan grinding filament midprint

    I have the following configuration on my CR-10: - Titan extruder with full size motor (was inside the E3D kit) - 45cm Capricorn XS PTFE Bowden...
    Thread by: Nazrim, May 9, 2018, 1 replies, in forum: Titan
  2. Thesecky
    Thread

    Titan extruder hobbed gear misaligned.

    Hi. I bought a new original titan extruder expecting some improvements over the fake one i had before. But as it turned out, the unit i recieved...
    Thread by: Thesecky, Nov 28, 2017, 5 replies, in forum: Titan
Showing results 1 to 2 of 2