Separate names with a comma.
I want to put a 7kg Dyze Pulsar pellet extruder on a toolchanger. and I want to move it at 1000mm/s, max loading of something like the following:...
Hi. Just assembled my tool changer and trying to set up S3D to work properly with it. Seems to be OK but I cannot get the part cooling fan to...
I updated from RRF2 to 3.2.2 and had some game stopper issues and thought I would share if anyone else runs into some issues. 1. Starting any...
In the thingiverse page for ASMBL, @Greg Holloway recommends using either Luvocom 3F PET CF 9780 (datasheet) or ColorFabb XT-CF20 (datasheet)...
Hello everyone, i made a new fan shroud for the Hemera, which i use in my ToolChanger. https://www.thingiverse.com/thing:4494858 [ATTACH]...
I came across this build by lorinczroby on Thingiverse, and I think it could be a good candidate for a low-mass direct drive for the tool-changer:...
Due to the Covid-19 lockout I was busy the last weeks. I'm working from home, but have plenty of time to do other things as well. Furthermore, I...
I need some advice to debug a part cooling fan issue. Tools 0, 1 and 2 work fine but Tool3 has an issues. I can not get M1064 P8 S255 to enable...
I am just about to order my ToolChanger kit. I'm on a pretty limited budget, but I am considering replacing the 4 Titans with 4 Hemera bowden...
