troubleshooting

  1. user64x
    Thread

    Hemera not extruding because faulty gear

    My E3D Hemera stopped extruding last week. I noticed the middle gear of the drive train is not moving. So I disassembled it. It turned out the...
    Thread by: user64x, Aug 20, 2020, 0 replies, in forum: Troubleshooting
  2. First_Chief
    Thread

    Issue with Y-Axis Calibration and Movement

    Hello, I am hoping to get some help with an issue I am having with my BigBox Hybrid Pro and I use Simplify3D. I had printed out the boat and...
    Thread by: First_Chief, Mar 28, 2017, 0 replies, in forum: Calibration, Help, and Troubleshooting
  3. Ethazeriel
    Thread

    E3d V6 unable to go higher than ~235 degrees

    Hi all, I'm hoping you'll be able to shed some light onto an issue I've been having - regardless of temperature setting, my V6 heating slows...
    Thread by: Ethazeriel, Dec 19, 2016, 5 replies, in forum: E3D-v6 and Lite6
  4. Thomas Piccione
    Thread

    Unable to Maintain Temperature on Lite6 at 230°

    OK, so I already did a PID autotune for my target temp of 230° C. on my hottend, but no matter how slow I go I cannot stop my hottend from dipping...
    Thread by: Thomas Piccione, Nov 22, 2016, 5 replies, in forum: E3D-v6 and Lite6
Showing results 1 to 4 of 4