0.15mm High Precision Nozzles Recommended Filament

Discussion in 'Calibration, Help, and Troubleshooting' started by Francesco P, May 7, 2017.

  1. Francesco P

    Francesco P New Member

    Joined:
    Mar 27, 2017
    Messages:
    1
    Likes Received:
    0
    Hello there I'm a lucky owner of the 0.15mm High Precision Nozzles , why PLA is not amongst the recommended materials to print with it? is it because it stay too long in the heat block hence will degrade and crystallise and ultimately clog the nozzle? any other reason?
    Thanks!
    Francesco
     
  2. elmoret

    elmoret Administrator

    Joined:
    Mar 1, 2014
    Messages:
    631
    Likes Received:
    101
    PLA doesn't flow quite as easily and 0.15mm is a pretty small hole to push material through.
     

Share This Page