1st print over PrusaSlicer 2.2 successful

Discussion in 'Getting Started' started by Mike Zimmermann, Aug 10, 2020.

  1. Mike Zimmermann

    Joined:
    Feb 1, 2018
    Messages:
    10
    Likes Received:
    6
    After some issues with mechanic and calibration settings I got a successful 3 color print. :)

    My printer is a transformed Hypercube Evolution with Linear Rails. I bought some parts from E3D to make a Tool Changer. Tools are 3 Bondtech Direct Extruders with E3D V6 and 1 Big Booster Bowden Hotend.

    During the print I could realized that the part fans runs sometimes not the right speed (Speed was from the tool before) I couldnĀ“t find any wrong commands in the g-code. Maybe FW issue with my Duet Wifi (3.1.1) or in my tpost.g file?
    Code:
    M106 R1             ; restore print cooling fan speed
    I have to improve some settings (temp, costatend ...)
    p1.jpg p3.jpg p2.jpg
     

Share This Page