25.2 main assemblies wiring

Discussion in 'Build Help' started by stoshu, Sep 26, 2016.

  1. stoshu

    stoshu Member

    Joined:
    Apr 13, 2016
    Messages:
    15
    Likes Received:
    0
    Here we are but the diagram shows 4 groups of red/black/green/blue wire combos. We only have 3 connected and unsure where the forth goes. This is a Dual hybrid. pic included. IMG_20160925_170032.jpg
     
  2. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,405
    Likes Received:
    731
    I can see the X motor cable, thats is the one in the back coming out of the sleeve from the back right corner...
    Then extruder 1 motor cable coming from the sleeve in the middle right, the one with most of the cables...
    And one motor cable lonely from one sleeve in the middle. That could be either Y motor or bowden extruder...
    Did you install the cable in 21.12 (21.12) Lower Spine?
    Or did you miss the Y axis motor cable at the end of 21.10 (21.10) Upper Spine?
     

Share This Page