I'm trying to print pla with greg wade belt driven extruder with e3dv6 print speed 30 temp nozzle 195 retract 20 mm pulling back 1 cant get a decent print to save my butt any suggestions for settings etc ready to push button on titan extruder. Thanks Gary
Where did you buy your hotend from? Did you assemble it according to the E3D instructions, including using thermal paste and doing the hot-tightening of the nozzle? 20mm retraction is too much, start with 0. You should not need more than 1mm with a direct drive setup. 195C is on the cool, side, try 205C, and 215C. Depending on the PLA, maybe even 225C. Can you post photos of your prints that are failing?