Adding a fourth extruder to the Rumba

Discussion in 'Multi-Extrusion' started by Tom De Bie, Aug 5, 2016.

  1. Michael Frampton

    Michael Frampton Well-Known Member

    Joined:
    Aug 5, 2016
    Messages:
    88
    Likes Received:
    7
    I listen to an American pod cast called "3d printing today"..they talk every episode about E3D hotends as benchmark..above all
     
  2. Valstrath

    Valstrath New Member

    Joined:
    Aug 16, 2017
    Messages:
    1
    Likes Received:
    0
    Hello,

    This a very useful article, I am also looking to ad a fourth extruder to my rumba board, but I already have the EXP3 pin 6 used for the BLtouch, is there any way to connect the expansion board to another pin? or does it has to be a PWM capable pin?

    Thanks
     
    #22 Valstrath, Dec 27, 2017
    Last edited: Dec 27, 2017

Share This Page