Anyone have a full 3d model of BB?

Discussion in 'BigBox General Chat' started by Stian Indal Haugseth, Mar 10, 2017.

  1. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    573
    Likes Received:
    95
    Hi,

    Does anyone have a full model of the BigBox with the enclosure? Preferably KS 1.0 but any variant will do.

    Would be nice to have for some mockups.

    _
    Stian
     
  2. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
  3. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    I know there are some things on Onshape, @Alex9779 I think has some of it models or maybe @Chase.Wichert

    @Björn has some IDEX available for fusion360 but its not 1.1
     
  4. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    573
    Likes Received:
    95
    Yes. The official docs is what I use. All the printer parts are there but not with enclosure. The enclosure is separate drawings.

    Downloaded @Björn model but only contains the Y + X carriage.
     
  5. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    758
    Likes Received:
    112
    Ah, I think the enclosure can be made from the drawings. I believe I was able to import them and use the extrude tool to make them into 3d models in f360 relatively easy. It might take a little time but you should be able to get all the parts in the model with not too much effort.
     
  6. Björn

    Björn Well-Known Member

    Joined:
    Mar 20, 2016
    Messages:
    213
    Likes Received:
    184
    '

    Most of the frame should be there? Perhaps hidden from view. Frame is composed from files found on onshape or was is grabcad? don't remember..
     
  7. Kanedias

    Kanedias Well-Known Member

    Joined:
    Sep 12, 2015
    Messages:
    406
    Likes Received:
    124
    C
    Could you post those files please? I found the files used for laser cutting don't have contiguous perimeters so couldn't be extruded without finding and fixing all the gaps.
     
  8. Stian Indal Haugseth

    Stian Indal Haugseth Well-Known Member

    Joined:
    Sep 11, 2015
    Messages:
    573
    Likes Received:
    95
    Yes. The frame is there, thanks. I did import all the other printer parts and tried aligning them. I thought all the parts from 123D would be in the correct position. But when I align one part others are a bit off.

    Need to verify if the 123D parts are a bit off or there is something wrong with your frame @Björn. I bet it's the 123d parts!
     

Share This Page