Auto home on Z not working

Discussion in 'Calibration, Help, and Troubleshooting' started by Miasmictruth, Apr 5, 2016.

  1. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    804
    Likes Received:
    118
    X and Y axis are homing fine, Z is moving in the correct direction.

    Whats not happening is every time I try to home the bed lowers a few mm and stops, so every time I home the bed gets lower.

    I have triple checked the wires for the IR sensor and they appear correct to the build manual. I have tried both the default Dual firmware and @Alex9779 firmware, both do the same thing.

    Any ideas why the Z wont home?
     
  2. Miasmictruth

    Miasmictruth Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    804
    Likes Received:
    118
    Sorry never mind I am an idiot, I triple checked the color code, not that I was in Z+ or Z-...
     
  3. Steven Burns

    Steven Burns Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    195
    Likes Received:
    55
    Funny.... I just did this exact same thing last week. I feel your pain!!
     

Share This Page