Bed Adhesion

Discussion in 'BigBox General Chat' started by xreymason, Mar 7, 2016.

  1. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    365
    Likes Received:
    106
    What is this!? An elixir from the gods! It's seems to be working fantastically. The same part that has been failing for me again and again is sticking like a demon! When it finishes let's hope it comes off!!
     
    mike01hu likes this.
  2. Rob Heinzonly

    Rob Heinzonly Well-Known Member

    Joined:
    Sep 20, 2015
    Messages:
    448
    Likes Received:
    174
  3. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    365
    Likes Received:
    106
    Beautiful! ;)
     
  4. Spoon Unit

    Spoon Unit Well-Known Member

    Joined:
    Sep 6, 2015
    Messages:
    1,546
    Likes Received:
    481
    Following the excitement here I picked up a can of Lock It. I seem to have the extra strong instead of ultra strong. So far so good though. I does hold PLA and the PLA is released when cold. Does seem a lot less messy than UHU and gives the bottom a predictable quality rather than a bit of mish mash on UHU.
     
  5. Syko_Symatic

    Syko_Symatic Well-Known Member

    Joined:
    Sep 4, 2015
    Messages:
    365
    Likes Received:
    106
    Glad it's working for others!
     

Share This Page