Bed level gcode

Discussion in 'Calibration, Help, and Troubleshooting' started by Eran Arviv, May 16, 2020.

  1. Eran Arviv

    Eran Arviv Member

    Joined:
    Feb 29, 2020
    Messages:
    2
    Likes Received:
    0
    Hello,
    I have a question that I cant quite find the answer to..
    I want to probe a specific spot on the bed over and over to adjust the knob to be on the spot I want!.
    Until now I used the g29 to mesh all the bed and from that i fine tuned everything and repeat the process few times until I was satisfied but the waiting for the g29 to finish the mesh just to know if just one spot is tuned as I wanted is killing me haha.
    So is there a gcode that can tell me on a specific spot what is the height?

    I am using duet 2 wifi bored and ir probe
     

Share This Page