Best Kossel Effector Platform for v6?

Discussion in 'E3D-v6 and Lite6' started by Botanicus, Aug 7, 2014.

  1. Botanicus

    Botanicus New Member

    Joined:
    Aug 7, 2014
    Messages:
    1
    Likes Received:
    0
    Hey all, I originally printed:
    http://www.thingiverse.com/thing:402022
    for my v6 hotend. Unfortunately it was printed on my bad jhead and wasn't very good quality. Due to trying to work out the clogs I've had on my v6 this guy has had some mistreatment...

    Next time I get my hotend up and running again I'll be reprinting an effector platform that will hopefully handle the stress a bit better. Does anyone have any recommendations? I don't mind printing this one again but it doesn't permit the autoprobe.

    Any advice would be appreciated. Once I get that taken care of I'll do additional research on the clogging issue. I've followed the Troubleshooting guide but still getting a lot of jamming which makes it a crap shoot on if I'm printing, or clearing, on a given day.

    thanks for all your help!
     

Share This Page