BigBox 1.1 dual titan hybrid - which one from Alex's firmware?

Discussion in 'Calibration, Help, and Troubleshooting' started by Proto_BB, Jul 25, 2016.

  1. Proto_BB

    Proto_BB Well-Known Member

    Joined:
    Jul 13, 2016
    Messages:
    77
    Likes Received:
    9
    I have a BigBox 1.1 with the titan upgrade. I have one direct extruder and one bowden. Having gone over grab a copy of Alex's firmware I have the following possible choices;

    1. Dual Titan
    2. Dual
    3. Hybrid Dual

    Which of these is applicable? I would have thought Dual Titan Hybrid.. but that's not there. I assume one of the three listed is what I need. But it's a toss up between #1 & #3.
     
  2. Alex9779

    Alex9779 Moderator
    Staff Member

    Joined:
    Sep 4, 2015
    Messages:
    2,411
    Likes Received:
    735
    #3
    Hybrid is what you are looking for.
    Dual Titan is two Titans in the print head...
     
    Proto_BB likes this.
  3. Proto_BB

    Proto_BB Well-Known Member

    Joined:
    Jul 13, 2016
    Messages:
    77
    Likes Received:
    9
    Thanks Alex. Much appreciated! I'm looking forward to mesh leveling!
     

Share This Page