BigBox from Mint - What should I do to improve it?

Discussion in 'General' started by Jon, Apr 26, 2022.

  1. Jon

    Jon Well-Known Member

    Oct 10, 2015
    Likes Received:

    First - I'm so gutted to hear about Sanjay - he was amazing

    I bought an original Bigbox Pro during the Kickstarter campaign, pre-assembled at E3D. Life got busy for a while and I've only just really got it going. I recently got Octoprint working on wifi finally - that took a while (I have a summary if what I did if anyone needs it), but beyond that I haven't done anything to the BB.

    I'm using Simplify 3D to slice.
    I'm printing with Colorfabb XT - a huge roll that's been on there for ages.

    My question is - are there essential things people think I should do to improve my prints?

    I'm planning on trying ArcWelder, and thinking about trying Cura 5.0.

    But what else? Hardware? Firmware?


Share This Page