BigBox Pro wont wait till heatup finished

Discussion in 'BigBox General Chat' started by Stigern, Aug 13, 2016.

  1. Stigern

    Stigern Well-Known Member

    Joined:
    Sep 8, 2015
    Messages:
    46
    Likes Received:
    7
    Suddenly my Pro will not wait until bed & extruder has reached temperatures, it just prints right away after it's home and level procedure.

    I'm using S3D and the profile found on bigbox pages, this is how my start script looks like in S3D:

    Code:
    ;BigBox Printer Start Script Begin
    
    M117 Print Starting.
    
    ;Home & Autolevel
    G28
    G29
    
    ;Dock
    G1 X70 Y200 F3000
    G1 X70 Y240 F3000
    
    ;Prime Extruder
    T0     ;Select Extruder 0
    G92 E0     ;Reset E
    G1 E10 F200     ;Extruder 10mm
    G92 E0     ;Reset E
    
    ;Undock
    G1 X80 Y240 F3000
    G1 X80 Y200 F3000
    
    ;BigBox Printer Start Script End
    
    Any ideas?

    EDIT:

    I did notcie that T0 is the same on both the bed and extruder temp control. That doesn't seem right?
     
    #1 Stigern, Aug 13, 2016
    Last edited: Aug 13, 2016

Share This Page