Black push fit for PTFE tube

Discussion in 'E3D-v6 and Lite6' started by batukhan, Apr 1, 2015.

  1. batukhan

    batukhan New Member

    Apr 1, 2015
    Likes Received:
    Today while trying to unjam my V6 (1.75mm), i broke the tiny pushfit that holds the PTFE tube in place. Without it, when trying to extrude, the PTFE tube just pushes out from the back of the hotend, so it's an absolutely essential part.
    I guess this is the one (black piece, on the left): ... m-Filament

    I was wondering if I could find this in some hardware/electronics store, or do I need to order it from E3D? I live in Estonia, so ordering a 5mm piece of plastic from the UK and waiting for 3 weeks sounds ridiculous.

    Thanks for any help

Share This Page