Bought the Volcano nozzle for my V6, like a muppet.

Discussion in 'E3D-v6 and Lite6' started by JOGARA, Jan 14, 2017.

  1. JOGARA

    JOGARA Member

    Joined:
    Jan 14, 2017
    Messages:
    2
    Likes Received:
    0
    So rushing yesterday to get a hardened nozzle I managed to order the volcano instead of the standard one for the V6.

    I guess I am okay lopping off the thread most of the way to get it around the same size as the stock one and using it like that?
    I'd of course make sure there were no bits of shards left that could clog up the bit...

    That okay?

    Ta
    Jack,
     
  2. JOGARA

    JOGARA Member

    Joined:
    Jan 14, 2017
    Messages:
    2
    Likes Received:
    0
    Might just order the right one. Or swap if E3D are up for it? I would pay the postage obviously.

    I doubt I could get a perfect just so that the filament doesn't come out everywhere..
     

Share This Page